Table of contents
Can be found at Quectel's Website, here (needs registration).
- The unit worked fine with a 2A, 3.6V power supply, which also powered an EPOSMote III.
- With 3.5V on the same power supply, the unit sends the URC (Unsolicited Result Code) "UNDER_VOLTAGE WARNING", and turns off sporadically (usually when communicating).
- Between 3.3V and 3.4V the unit warns about the under voltage and turns on very quickly (about 10 seconds).
The following commands can be used to check if everything is OK after powering on the device.
Commands are shown with a >> prompt, the following lines represent the data received back from the modem.
>> AT OK >> AT+CPIN? +CPIN: READY OK
The command AT should always be responded with OK. The AT+CPIN? command checks if the SIM card needs unlocking, and will return +CME ERROR: 10 in case the SIM card is not present. Refer to the AT Commands manual for other cases.
The following commands are needed to attach to the GPRS network and transmit/receive data.
>> AT+CGDCONT=1,"IP","gprs.oi.com.br" OK >> AT+CGACT=1,1 OK >> AT+CGATT=1 OK
- Define a PDP (Packet Data Protocol) context for the connection, using IP, where the second string (in our case "gprs.oi.com.br" is the APN (Access Point Name) for your provider. You may need to search the internet for your case.
- Activate the context we just created.
- Attach to the GPRS network.
Refer to the AT Commands manual for more detail if needed.
You can easily open a TCP/IP connection with the (Quectel-specific) AT+QIOPEN command as follows.
>> AT+QIDNSIP=1 OK >> AT+QIOPEN="TCP","tarcis.io","80" OK CONNECT OK
The first command, AT+QIDNSIP is used to signal the module whether you will use an IP address or a qualified domain name in the AT+QIOPEN command. If you are using an IP address instead of a domain name, omit it or explicitly send AT+QIDNSIP=0.
Now to send data over the open connection, use the AT+QISEND command.
>> AT+QIOPEN="TCP","tarcis.io","80" OK CONNECT OK >> AT+QISEND > >> test >> 0x1a (send as hex input, this is a CTRL+Z character) SEND OK HTTP/1.1 400 Bad Request Server: nginx/1.6.2 Date: Fri, 26 Jun 2015 20:16:54 GMT Content-Type: text/html Content-Length: 172 Connection: close <html> <head><title>400 Bad Request</title></head> <body bgcolor="white"> <center><h1>400 Bad Request</h1></center> <hr><center>nginx/1.6.2</center> </body> </html> CLOSED
In this example, a test string was sent, and a response was received from the nginx server, which, obviously, didn't understand the request.